This silicone sleeve fits The Leaf razor, providing additional grip. It is custom molded out of silicone to fit the handle perfectly. You can slide it on, and remove it whenever you like. 

Your Leaf Razor Grip Sleeve slides onto the handle from the bottom. You'll notice that it is perfectly molded to the shape of the handle. First, wet the handle of your razor and apply a small amount of soap, this will allow the sleeve to easily slip on. Hold the sleeve in your other hand firmly (or wrap a towel around it) and carefully slide it onto The Leaf Razor handle. The 'small opening' goes on first. Pull it up until the top falls right below the knuckle of your razor. Then, thoroughly rinse off the handle, get the soap off the handle working around and underneath the grip sleeve until it stays put.

Step 1

First, wet the handle of your razor and apply a little soap, this will slick up your handle and allow the sleeve to slide on easily.

Step 2

Then, sliding it on small-end first, wrap the grip in a towel and slide it onto the handle of your razor. The waffle grip pattern will be facing upward, or "on top" of the razor when the blades are facing down. Slide it up until it sits right below the knuckle.

Step 3

Then, rinse free the soap from around and underneath the grip sleeve. Keep rinsing until the soap is completely gone, this will allow the grip to settle in and stick to the handle.

Dry your razor and enjoy!

Remove the grip periodically when you perform deep cleanings on your razor, re-apply the grip using the above instructions afterward.